Information on Malfunctions and Care of your Model 8 & 81
-
uhjohnson
- Posts: 150
- Joined: Wed Aug 25, 2010 3:53 pm
Post
by uhjohnson » Sun Sep 09, 2018 11:33 am
I have three barrel assemblies and I cannot get the bjb's off. I have the flip tool for both the barrel nut and bjb. I broke the bjb's side and had another made and will only use it on bushings that I have freed up.I have been soaking the bushings in kroll for months and have heated them to the point of licking my finger and it sizzless to the touch. After soaking I have been using a ruler out of a machinists square and a 16 inch adjustable wrench to no avail. If I had an infrared thermometer, what would be a safe temperature to heat the jacket to.
If I can't get it with anyones suggestion should I cut the bjb from the inside. I just bought 3 NOS bushings of of ebay.

[b]Member of Berwyn Rod and Gun Club since 1983, it is an outdoor range located in Bowie Maryland, if interested in joining call 301-261-7515 or 301-464-9830[/b]
You don't pay too much, you pay too soon
-
kenhwind
- Posts: 167
- Joined: Tue Jun 23, 2009 6:50 am
Post
by kenhwind » Sun Sep 09, 2018 5:15 pm
The biggest problem with heating the barrel jacket is it soften the solder under the front sight base.
KEN
-
Fred
- Posts: 72
- Joined: Wed Feb 26, 2014 11:10 pm
Post
by Fred » Mon Sep 10, 2018 2:35 pm
I'd have a tool
like this one made out of a grade-8 nut and use heat plus an impact wrench on the bushing to free it up. If all else fails, then anyone with a lathe can cut the bushing out instead.
-
Phyrbird
- Posts: 838
- Joined: Mon Jan 07, 2013 10:53 pm
Post
by Phyrbird » Tue Sep 11, 2018 6:26 pm
I'm pretty certain the sight block is brazed. It would likely cause scale from heat to remove. I have one some nitwit removed, toasty. Another option for the removal could be to use some medical freeze R134 to cool the barrel bushing after heating the sleeve. If that don't do it you may be in real trouble....
Carl
Phyrbird
SOKY
-
chas1949
- Posts: 59
- Joined: Wed Oct 02, 2013 12:40 pm
Post
by chas1949 » Wed Sep 12, 2018 9:54 am
here is a method I have used a couple of times to remove barrel jacket bushings that were rusted and could not be removed. This will however ruin the bushing.
Take a large pair of vise grips and clamp on the bushing at the notched ring as tight as possible. This will deflect the bushing enough for penetrant to creep into the threads. Repeat this at 90 degrees and allow to soak a bit. Use vise grips to attempt to turn bushing out being careful not to break small pin that keeps barrel jacket from turning in the barrel jacket head.
Who is online
Users browsing this forum: No registered users and 2 guests