what have I got?

Ask about your Model 8 & 81
Post Reply
miwoods
Posts: 24
Joined: Sun Oct 09, 2016 7:03 pm

what have I got?

Post by miwoods »

I have a 1929 production model 8, 30 Rem. I think I have a rifle put together with parts. I discovered it had a 35 Rem buffer spring installed.

I next decided to replace a broken buttplate. My buttplate is curved bakelite, 4 7/16 x 1 9/16. It does not have the circle in the middle, rather "Remington" in a horizontal box near the top, and then a series of horzontal grooves running down until the area where the bottom screw hole is, which is smooth. I have seen pictures on the net of flat buttplates in this size and design for the model 14, but not for the model 8.

I this probably the correct buttplate or even butt stock for this rifle?
miwoods
Posts: 24
Joined: Sun Oct 09, 2016 7:03 pm

Re: what have I got?

Post by miwoods »

anyone??
User avatar
81police
Posts: 2613
Joined: Thu Feb 05, 2009 12:12 pm
Location: TEXAS

Re: what have I got?

Post by 81police »

picture of the buttplate in question??
Cam Woodall
Site Co-Administrator
miwoods
Posts: 24
Joined: Sun Oct 09, 2016 7:03 pm

Re: what have I got?

Post by miwoods »

Here is a photo. I am currently using epoxy to fill in a missing piece and have not completed the process. The plate is 4 7/16 x 1 9/16.

This is dimension is smaller than others I have read about.
IMG_1179.JPG
IMG_1179.JPG (59.46 KiB) Viewed 10213 times
User avatar
81police
Posts: 2613
Joined: Thu Feb 05, 2009 12:12 pm
Location: TEXAS

Re: what have I got?

Post by 81police »

this is NOT a Model 8 or 81 buttplate
Cam Woodall
Site Co-Administrator
miwoods
Posts: 24
Joined: Sun Oct 09, 2016 7:03 pm

Re: what have I got?

Post by miwoods »

81police wrote: Sun Aug 13, 2017 4:15 pm this is NOT a Model 8 or 81 buttplate
That is what I suspected. Does anyone know if a 8 or 81 butt was ever made as small as 4 7/16 x 1 9/16?

The butt stock fits into the receiver very nicely, but the small butt measurement makes me suspect a very good fitting job with an incorrect stock.
User avatar
81police
Posts: 2613
Joined: Thu Feb 05, 2009 12:12 pm
Location: TEXAS

Re: what have I got?

Post by 81police »

I don't know buttplate measurements, just know which ones were factory and which aren't. There never was a plastic plate used on 8's, but turn of the century gutta percha, basically like Bakelite. They're brittle nowadays and can fracture if shot in a hard rest or dropped. 81's only ever had 1 buttplate, made either in steel (early) or aluminum
Cam Woodall
Site Co-Administrator
Post Reply