ISO: Rear Sight threaded block/Williams Mount

Items wanted
Post Reply
Ozanicr
Posts: 3
Joined: Mon Nov 30, 2020 11:59 am

ISO: Rear Sight threaded block/Williams Mount

Post by Ozanicr »

Hello,

I recently obtained a Model 8 and am new to the forum. My rifle was missing the rear sight, and has a tang sight installed. I was able to obtain a Lyman flip down sight, dovetail block and screws, but am unable to find the block to thread the screws into. My rifle is also drilled and tapped for what I’ve found to be a Williams side mount. If anyone could direct me to either of these items it would be much appreciated.

Ryne
kenhwind
Posts: 265
Joined: Tue Jun 23, 2009 6:50 am

Re: ISO: Rear Sight threaded block/Williams Mount

Post by kenhwind »

Is this what you are ISO:
Image
KEN
Ozanicr
Posts: 3
Joined: Mon Nov 30, 2020 11:59 am

Re: ISO: Rear Sight threaded block/Williams Mount

Post by Ozanicr »

Yes that is the elusive item I have been looking for! Finally able to see what it looks like. Thank you for submitting the picture.
kenhwind
Posts: 265
Joined: Tue Jun 23, 2009 6:50 am

Re: ISO: Rear Sight threaded block/Williams Mount

Post by kenhwind »

Hey you're in luck. Went to check pricing and found this:
https://www.gunpartscorp.com/products/1759330
KEN
Ozanicr
Posts: 3
Joined: Mon Nov 30, 2020 11:59 am

Re: ISO: Rear Sight threaded block/Williams Mount

Post by Ozanicr »

Thank you very much for your help, I had checked that site but was unable to locate that part. I did not realize there is a section of parts non diagramed. Thanks Again!
Post Reply