Page 1 of 1
What cup tip punches?
Posted: Tue Feb 24, 2015 9:06 pm
by In The Ten Ring
I know Henwood's book called for #2 and #3 but I must have gotten something wrong. I need the one for the trigger guard retaining pin that goes through the receiver from side to side. What size cup tip punch do I need?
Re: What cup tip punches?
Posted: Wed Feb 25, 2015 2:35 pm
by h.charlie
It doesn't need to be a cup tip, I just use a Bostitch 1/16 or 1.5mm punch to get it out
Re: What cup tip punches?
Posted: Wed Feb 25, 2015 7:11 pm
by In The Ten Ring
Henwood suggests cup tip punches and the pins on my weapons are convex at their heads.
I realize standard punches will work but there goes the convex pin heads.
Re: What cup tip punches?
Posted: Wed Feb 25, 2015 9:39 pm
by Sarge756
OK...All that is standing in the way is a few $$$.....
http://www.brownells.com/gunsmith-tools ... od656.aspx
Re: What cup tip punches?
Posted: Thu Feb 26, 2015 1:41 pm
by h.charlie
Haha 100 bucks for a set of eight, at that price I rather make my own! My pins are flat from the 103 years of others beating the snaught out of them, in fact I never knew there were pin heads to start with until now
Re: What cup tip punches?
Posted: Thu Feb 26, 2015 1:43 pm
by h.charlie
If you are in a hurry I've used the head of finish nails to punch out pins on other projects cause they have a concave head just fthought food for thought
Re: What cup tip punches?
Posted: Thu Feb 26, 2015 4:58 pm
by jim8008
There are lots of pinheads. Duck.
Re: What cup tip punches?
Posted: Fri Feb 27, 2015 3:34 pm
by In The Ten Ring
One thing I have learned, don't be in a hurry if you can keep from it.
I'll try and get the whole set then, but it's on backorder right now at Brownell's.
The Model 8 I want to take apart is very minty and the convex pins are still convex.