New Guy

New Member Introductions
Post Reply
User avatar
ChrisB
Posts: 4
Joined: Thu Aug 25, 2016 8:45 am

New Guy

Post by ChrisB » Thu Aug 25, 2016 9:14 am

Hello everybody. I recently took an interest in my M81 CIRCA 1946 in .300 Sav. I inherited it from my grandfather. I'm not new to guns, but I am new to this one. So far, I've taken it apart except for the barrel & shroud and cleaned the last 70 years of nasty out of it. I've also reconditioned the stock and replaced a buttcap screw. I still need to get the barrel & shroud apart and get it cleaned and lubed. It's looking like a shooter and I'd like to use it as my grandfather did. I'm hoping to make this my ole faithful deer slayer. That being said, since there seems to be a deficiency in available barrel tools, I'm going to make some, a single pin spanner and bushing wrench. They'll be similar to the illusive CBR Pro Set.
Attachments
My 81.jpg
My 81.jpg (137.5 KiB) Viewed 3408 times

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests