barrel nut removal

Talk about things other than the Model 8's and 81's
Post Reply
1907 32
Posts: 11
Joined: Mon Sep 11, 2017 4:34 pm

barrel nut removal

Post by 1907 32 » Mon Oct 02, 2017 6:02 pm

Hey Guys,
I purchased a barrel nut removal tool from ROBOPUMP and this thing works great. This tool made removal easy. one handed and is a solidly built tool. The best part is tip can be re-ground time after time, if you have to. The hardened steel tip should last defiantly. Yes I made an eye bolt and punch tool which worked fine but left me wishing I made a third hand. Thanks ROBOPUMP job well done.
1907 32.

Posts: 34
Joined: Wed Oct 02, 2013 12:40 pm

Re: barrel nut removal

Post by chas1949 » Wed Oct 04, 2017 2:03 pm

Barrel nut tool.jpg
Barrel nut tool.jpg (347.2 KiB) Viewed 675 times

Yes I felt the same way after I made this and used it so I drilled a second hole in the end of the eye.
This was tapped to 10-32 to accept a 10-32 dog point set screw 5/8 in long. Dog point had to be filed down just a bit with a small file to fit in barrel nut hole. Just chucked set screw in the Dewalt and it only took and minute to get the job done.
Now just a 2 handed job.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest