Search found 6 matches
- Thu Feb 02, 2017 12:09 am
- Forum: Welcome Wagon
- Topic: Hello to all
- Replies: 4
- Views: 5025
Re: Hello to all
That seams to have been the problem only had three rounds to test but it ate them without complaint. I'll report back after I load some back up and test more extensively. Thanks guys
- Wed Feb 01, 2017 7:44 am
- Forum: General
- Topic: 30-30 dies for 30 Rem
- Replies: 7
- Views: 7152
Re: 30-30 dies for 30 Rem
I just got my RCBS 30 Rem dies from Midway last week for $61 and I believe Grafs had them for $70. I really like Hornady dies due to the bullet alignment tube in the seating die but they were $200 for custom made even though the still make 25 Rem. So I might get a set of Hornady 30-30 dies and use t...
- Tue Jan 31, 2017 7:13 am
- Forum: Troubleshooting / Maintenance
- Topic: Where can I get the barrel nut spanner wrench?
- Replies: 5
- Views: 5547
Re: Where can I get the barrel nut spanner wrench?
I used the drilled socket on a 1924 that I know hadn't been apart for over 40 years. Find a socket that fits over the barrel nut then find the drill bit that the smooth side fits the spanner hole. Drill the socket the right height then use the back side of the drill bit for the pin it's hardened so ...
- Wed Dec 21, 2016 7:54 am
- Forum: Welcome Wagon
- Topic: Hello to all
- Replies: 4
- Views: 5025
Re: Hello to all
Thank you. That is one thing I didn't disassemble I will check that out. I was also trying to come up with possible causes can...
1) recoil spring in barrel shroud be the issue
2) magazine side spring be holding the round to deep in the magazine
1) recoil spring in barrel shroud be the issue
2) magazine side spring be holding the round to deep in the magazine
- Mon Dec 19, 2016 12:17 am
- Forum: Q & A about the 8/81
- Topic: M8 Remington markings
- Replies: 2
- Views: 3442
Re: M8 Remington markings
I have one showing 1924 by this sites information and its marked "MODEL 8" on the shroud ahead of the patient info
- Sun Dec 18, 2016 9:46 pm
- Forum: Welcome Wagon
- Topic: Hello to all
- Replies: 4
- Views: 5025
Hello to all
I'm working on a model 8 in 30rem made in 1924. It was my fathers first gun and the only info I could ever get was it would fire once then jam badly. I fully disassembled the receiver for cleaning and took it out for test shots. It fires ejects and fails to feed repeatedly until the last round when ...